Choosing microphones by habit rather than by room
- Listen to the room before choosing a pickup pattern
- Note every noise source near the talent position
- Confirm framing with the director before rigging booms
Setting gain late and trusting the meters alone
- Set gain with talent speaking at full programme volume
- Keep headroom at every stage, not just the output
- Check by ear as well as by meter
Leaving monitoring as an afterthought
- Use the same monitors throughout the job
- Listen at low level before approving a mix
- Keep the broadcast mix separate from the house mix
Ignoring phase, polarity and radio frequency clashes
- Test polarity with one voice before opening a second microphone
- Scan for clear frequencies at every new venue
- Share the wireless plan with all crews on site
Skipping a full run of the final feed
- Test tone and speech along the whole signal path
- Repeat the check after every change to the rig
- Agree a talkback line between audio and gallery
Writing nothing down for the next crew
- Record inputs, positions and gain settings after each job
- Note venue quirks while they are fresh
- Store the page with the production files
None of these mistakes needs expensive equipment to fix. They come down to listening to the space first, setting levels with care, monitoring honestly, planning radio use, testing the whole path and writing down what worked. As the evenings draw in and indoor shoots and events fill the diary, it is a good moment to review your own audio routine before the busy weeks begin.